OIL PUMP REMOVAL

CAUTION / NOTICE / HINT

Note

Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.

PROCEDURE


  1. REMOVE ENGINE AND TRANSAXLE

    Click here

  2. DISCONNECT ENGINE WIRE


    1. Disconnect the connectors and clamps securing the engine wire from the engine.

  3. REMOVE IGNITION COIL ASSEMBLY

    Click here

  4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY


    1. A01V74B

      Remove the 16 bolts, 3 seal washers, cylinder head cover sub-assembly and cylinder head cover gasket.

    2. A01V84Y

      Remove the 2 camshaft bearing cap oil hole gaskets from the No. 1 camshaft bearing cap.

    3. Remove the gasket from the No. 2 camshaft bearing cap.

  5. REMOVE SPARK PLUG TUBE GASKET


    1. A01VA92

      Using a screwdriver, pry out the 4 spark plug tube gaskets.

      Note

      Be careful not to damage the cylinder head cover sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

  6. REMOVE CRANKSHAFT POSITION SENSOR

    Click here

  7. REMOVE CRANKSHAFT PULLEY

    Click here

  8. REMOVE ENGINE MOUNTING BRACKET RH


    1. A01V7J3

      Remove the 4 bolts and engine mounting bracket RH.

  9. REMOVE DUST COVER (w/ Cover)

    Click here

  10. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

    Click here

  11. REMOVE TIMING CHAIN COVER ASSEMBLY


    1. A01VAUI

      Remove the 17 bolts and 2 nuts.

    2. A01V7KFC01
      *1 Protective Tape

      Remove the timing chain cover sub-assembly by prying between the timing chain cover sub-assembly and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.

      Note

      Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase and timing chain cover sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01VAUW

      Remove the 2 oil pump gaskets from the stiffening crankcase.

    4. Remove the oil hole cover gasket from the stiffening crankcase.

  12. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A01V9ASC01
      *1 Protective Tape
      *2 Wooden Block

      Using a screwdriver and wooden block, pry out the oil seal.

      Note

      Do not damage the surface of the oil seal press fit hole.

      Tech Tips

      Tape the screwdriver tip before use.