FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. A01V9S0E01

      Apply MP grease to the lip of a new timing chain cover oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the timing chain cover oil seal.

      • Do not allow MP grease to contact the timing chain cover oil seal.

    2. Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

      SST
      09223-22010

      Note


      • Wipe off any extra grease from the crankshaft.

      • Do not tap in the timing chain cover oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. A01VADHC03
      *a Hold
      A01V9RL Turn

      Align the key groove of the crankshaft pulley with the pulley set key.

    2. Temporarily install the crankshaft pulley with the pulley bolt.

    3. Using SST, hold the crankshaft pulley in place and tighten the pulley bolt.

      SST
      09213-54015
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

      Tech Tips

      The part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSPECT V-RIBBED BELT

    Click here

  5. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  6. ADD ENGINE OIL

    Click here

  7. INSPECT FOR OIL LEAK

    Click here

  8. INSTALL REAR ENGINE UNDER COVER RH

    Click here

  9. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  10. INSTALL NO. 2 CYLINDER HEAD COVER

    Click here