CAUTION / NOTICE / HINT
PROCEDURE
INSTALL THROTTLE BODY ASSEMBLY
Install a new gasket to the intake manifold.
for Type A:
Install the throttle body assembly with the 2 bolts and 2 nuts.
for Type B:
Install the throttle body assembly with the 4 bolts.
Connect the water by-pass hose and No. 2 water by-pass hose, and slide the 2 clamps to secure them.
Connect the throttle body assembly connector.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY
Install the air cleaner cap sub-assembly. Then, release the lock of the air cleaner cap sub-assembly clamp to secure the clamp.
Connect the PCV hose to the cylinder head cover sub-assembly, and slide the clamp to secure it.
Connect the 2 clamps.
Attach the wire harness to the air cleaner cap sub-assembly.
Connect the mass air flow meter connector.
INSTALL NO. 2 CYLINDER HEAD COVER
Attach the 4 clips to install the No. 2 cylinder head cover.
Note
Be sure to attach the clips securely.
Do not apply excessive force or hit the No. 2 cylinder head cover to attach the clips. This may cause the No. 2 cylinder head cover to break.
ADD ENGINE COOLANT
INSPECT FOR COOLANT LEAK
INSTALL NO. 1 ENGINE UNDER COVER
PERFORM INITIALIZATION
Note
Be sure to perform this procedure after reassembling the throttle body assembly or removing and reinstalling any throttle body component.
Perform the following procedure after replacing the ECM, throttle body assembly or any throttle body components. The following procedure should also be performed if the throttle body assembly is cleaned.
Be sure to perform this procedure after replacing the ECM and reconnecting the battery cable.
Disconnect the EFI MAIN and ETCS fuses at the same time. Wait at least 60 seconds, and then reconnect the fuses.
Turn the ignition switch to ON without operating the accelerator pedal.
Note
If the accelerator pedal is operated, perform the above steps again.
Connect the GTS to the DLC3 and clear the DTCs.
Start the engine and check that the MIL is not illuminated and that the idle speed is within the specified range when the A/C is switched off after the engine is warmed up.
Standard Idle Speed | ||||||
---|---|---|---|---|---|---|
|
Note
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in neutral (for Manual Transaxle), or N or P (for CVT).
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.
Tester Display |
---|
Throttle Sensor Position |
Perform a road test and confirm that there are no abnormalities.