REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE ENGINE AND TRANSAXLE

    Click here

  2. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)


  3. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)


  4. FIX ENGINE ASSEMBLY

    Click here

  5. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)

    Click here

  6. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)

    Click here

  7. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)


    1. A01QR2EE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holdingtool): 91551-80650 (quantity: 2)

    2. A01QROF

      Remove the 8 bolts and flywheel.

  8. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)


    1. A01QR2EE01

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holdingtool): 91551-80650 (quantity: 2)

    2. A01QPY4

      Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.

  9. REMOVE REAR ENGINE OIL SEAL


    1. A01QR51C03
      *1 Cut Position
      *2 Protective Tape

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      Note

      Do not damage the surface of the oil seal press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.