СИСТЕМА КРУИЗ-КОНТРОЛЯ (для моделей с 1ND-TV с ЭБУ помощи при движении), Diagnostic DTC:P1615

DTC Code DTC Name
P1615 Communication Error from Distance Control ECU to ECM

DESCRIPTION

The driving support ECU assembly and ECM always communicate the data for vehicle general control and diagnosis function to each other via a communication line.

The driving support ECU assembly sends a control demand signal to the ECM.

DTC No. Detection Item DTC Detection Condition Trouble Area
P1615 Communication Error from Distance Control ECU to ECM While the cruise control is either preparing for operation or operating, communication data from the driving support ECU assembly is logically inconsistent for a certain amount of time, the ECM stores this DTC.
  • Driving support ECU assembly

  • ECM

CAUTION / NOTICE / HINT

Note

The cruise control system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the cruise control system after confirming that the communication systems are functioning properly.

Click here

PROCEDURE


  1. REPLACE DRIVING SUPPORT ECU ASSEMBLY


    1. Replace the driving support ECU assembly.

      Click here

      Note

      When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

      Result
      Proceed to
      NEXT

    NEXT
  2. CHECK FOR DTCS (DTC P1615)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Clear the DTCs.

      Click here


      Powertrain > Engine and ECT > Clear DTCs
    4. Perform the following to make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the malfunction cannot be detected.


      1. Drive the vehicle at a speed for which cruise control operation is possible.

      2. Turn the cruise control system on using the cruise control switch (ON-OFF button).

    5. Check for DTCs.

      Click here


      Powertrain > Engine and ECT > Trouble Codes
      Result
      Result Proceed to
      DTC P1615 is not output A
      DTC P1615 is output B
    6. Turn the ignition switch off.


    A
    B