СИСТЕМА КРУИЗ-КОНТРОЛЯ (кроме моделей с 1ND-TV, 8NR-FTS) ПРОЦЕДУРА ПОИСКА НЕИСПРАВНОСТЕЙ

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   VEHICLE BROUGHT TO WORKSHOP

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
2. Click here

   INSPECT BATTERY VOLTAGE

   
   

   1. Measure the battery voltage with the ignition switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
3. Click here

   CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

   
   

   1. Use the GTS to check if the CAN communication system is functioning normally.

      Result
      Result Proceed to CAN DTC is not output A CAN DTC is output B

   
   
   • AClick here
   • B

     GO TO CAN COMMUNICATION SYSTEMClick here

4. Click here

   CHECK FOR DTC*

   Refer to DTC Check / Clear.

   Click here

   
   

   1. Check for DTCs and note any codes that are output.

   2. Clear the DTCs.

   3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      Result
      Result Proceed to DTC does not reoccur A DTC reoccurs B

   
   
   • AClick here
   • B

     GO TO DTC CHARTClick here

5. Click here

   PROBLEM SYMPTOMS TABLE

   Refer to Problem Symptoms Table.

   Click here

   Result
   Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B

   
   
   • AClick here
   • BClick here

     GO TO STEP 7

6. Click here

   OVERALL ANALYSIS AND TROUBLESHOOTING*

   
   

   1. Terminals of ECU

      Click here

   2. Data List / Active Test

      Click here

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
7. Click here

   ADJUST, REPAIR OR REPLACE

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
8. Click here

   CONFIRMATION TEST

   Result
   Proceed to NEXT

   
   
   • NEXT

     END