СТАРТЕР (для моделей с системой запуска и останова) СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

      Click here

    • When the starter assembly is replaced, "starter relay assembly" must be also replaced.

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

  5. REMOVE BATTERY

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 3 AIR HOSE

    Click here

  9. REMOVE NO. 2 AIR TUBE

    Click here

  10. REMOVE NO. 1 AIR TUBE

    Click here

  11. REMOVE STARTER ASSEMBLY


    1. B0043GZ

      Open the terminal cap.

    2. Remove the nut and disconnect terminal 30.

    3. Disconnect the starter assembly connector.

    4. B00441U

      Remove the 2 bolts and starter assembly.