СВЕЧА НАКАЛИВАНИЯ (для моделей без контроллера свечей накаливания) ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

PROCEDURE

1. INSPECT GLOW PLUG ASSEMBLY

   
   

   1. Remove the No. 1 glow plug connector.

      Click here

   2. 

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition Glow plug assembly terminal - Ground 20°C (68°F) 0.7 Ω or higher

      Note

      
      

      • Do not damage the glow plug pipes as this could cause an open circuit or shorten the life of the glow plug assembly.

      • Prevent oil and fuel from spraying onto the glow plug assembly when cleaning.

      • Wipe any oil off the terminal and the Bakelite washer with a dry cloth if they are stained with oil during the inspection.

      If the result is not as specified, replace the glow plug assembly.

   3. Install the No. 1 glow plug connector.

      Click here