GLOW PLUG(w/o Glow Plug Controller) REMOVAL
PROCEDURE
PRECAUTION
Note:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.
REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
WARM UP ENGINE
Note:The glow plug assembly may be damaged if it is removed before the engine is warmed up.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE NO. 3 ENGINE COVER BRACKET
-
Disconnect the wire harness clamp.
Remove the bolt and No. 3 engine cover bracket.
-
REMOVE NO. 1 GLOW PLUG CONNECTOR
-
Remove the 5 screw grommets.
-
*1
Wire Harness
Remove the nut and disconnect the wire harness.
Remove the 4 nuts and No. 1 glow plug connector.
-
REMOVE GLOW PLUG ASSEMBLY
-
Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.
Note:Do not remove the glow plug assemblies before the engine is warmed up.
-