LIGHTING SYSTEM Back Door Courtesy Switch Circuit

DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the back door courtesy switch built in the back door lock assembly.

WIRING DIAGRAM

A0139F0E10

PROCEDURE


  1. READ VALUE USING GTS


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.


      Body Electrical > Main Body > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Back Door Courtesy SW Back door courtesy switch signal ON or OFF

      ON: Back door open

      OFF: Back door closed

      -

      Body Electrical > Main Body > Data List
      Tester Display
      Back Door Courtesy SW
      OK
      Normal conditions listed above are displayed.
      Result
      Proceed to
      OK
      NG

    OK
    NG
  2. INSPECT BACK DOOR LOCK ASSEMBLY


    1. Remove the back door lock assembly.

      for Hatchback: Click here

      for Wagon: Click here

    2. Inspect the back door courtesy switch built in the back door lock assembly.

      for Hatchback: Click here

      for Wagon: Click here

      OK
      Back door lock assembly is normal.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND BODY GROUND)


    1. Disconnect the 3E instrument panel junction block assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Q3-3 (D+) - 3E-34 Always Below 1 Ω
      Q3-3 (D+) - Body ground Always 10 kΩ or higher
      Q3-2 (ACT-) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


    1. Remove the instrument panel junction block assembly.

      for RHD: Click here

      for LHD: Click here

    2. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

    3. Measure the resistance according to the value(s) in the table below.

      A013B0DC05
      *a

      Component without harness connected

      (Instrument Panel Junction Block Assembly)

      - -
      Standard Resistance
      Tester Connection Condition Specified Condition
      3E-34 - MB-20 (BCTY) Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK
    NG