ПЕРЕДНИЙ ПРИВОДНОЙ ВАЛ В СБОРЕ (для моделей с 1ND-TV) СНЯТИЕ

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEELS

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  3. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  4. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  5. DRAIN MANUAL TRANSAXLE OIL

    for Manual Transaxle: Click here

    for Multi-Mode Manual Transaxle: Click here

  6. REMOVE FRONT AXLE SHAFT NUT


    1. B0044NAN05

      Using SST and a hammer, release the staked part of the front axle shaft nut.

      SST
      09930-00010

      Note

      Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

    2. While applying the brakes, remove the front axle shaft nut.

  7. SEPARATE FRONT SPEED SENSOR

    Click here

  8. SEPARATE FRONT FLEXIBLE HOSE

    Click here

  9. SEPARATE TIE ROD END SUB-ASSEMBLY

    Click here

  10. SEPARATE FRONT STABILIZER LINK ASSEMBLY

    Click here

  11. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

    Click here

  12. SEPARATE FRONT DRIVE SHAFT ASSEMBLY

    Click here

  13. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH


    1. B0041P6N08

      Using SST, remove the front drive shaft assembly LH.

      SST
      09520-01010
      09520-24010   ( 09520-32040 )

      Note


      • Do not damage the transmission case oil seal.

      • Do not damage the front axle inboard joint boot.

      • Do not drop the front drive shaft assembly LH.

  14. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  15. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH


    1. B0041XH

      Using a screwdriver, remove the front drive shaft hole snap ring.