ДАТЧИК ВЫБОРА ПЕРЕДАЧ СНЯТИЕ

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  2. REMOVE FUEL FILTER ASSEMBLY

    Click here

  3. DISCONNECT ENGINE WIRE

    Click here

  4. REMOVE FUEL FILTER SUPPORT

    Click here

  5. REMOVE AIR CLEANER BRACKET

    Click here

  6. REMOVE SELECT STROKE SENSOR


    1. A00Y7VU

      Disconnect the 2 wire harness clamps.

    2. A00Y758

      Disconnect the select stroke sensor connector.

    3. A00Y7ZH

      Remove the 2 screws and select stroke sensor from the shift and select actuator.

    4. Remove the O-ring from the select stroke sensor.