THEFT DETERRENT SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use this procedure to troubleshoot the theft deterrent system.

  • *: Use the intelligent tester.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. CUSTOMER PROBLEM ANALYSIS


    1. Interview the customer to confirm the trouble Click here.


      NEXT

  3. SYMPTOM SIMULATION


    NEXT

  4. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the intelligent tester to check if the CAN Communication System is functioning normally Click here.

      Result
      Result Proceed to
      CAN DTC is not output A
      CAN DTC is output B

      B

      GO TO CAN COMMUNICATION SYSTEM Click here

      A

  5. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 7
      A

  6. PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM*


    1. System Description Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test Click here

  7. REPAIR OR REPLACE


    NEXT

  8. CONFIRMATION TEST


    NEXT
    END