HEADLIGHT LEVELING SWITCH REMOVAL


  1. PRECAUTION (for RHD with Smart Entry and Start System)

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)


    1. Disable the auto away/return function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the auto away/return function is enabled or disabled) in order to restore the current setting after finishing this operation.

    2. Turn the ignition switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. B000HXQ

      Disconnect the front door opening trim weatherstrip LH.

  5. REMOVE INSTRUMENT SIDE PANEL


    1. B000HH8

      Using a moulding remover, disengage the 4 claws as shown in the illustration.

    2. B000MY7

      Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

  6. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)


    1. B000H9B

      Disengage the 2 claws and 4 clips to remove the upper instrument panel finish panel as shown in the illustration.

    2. w/ Smart Entry and Start System:


      1. Disconnect the connector.

  7. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. B000J4N

      Disengage the 4 clips to remove the No. 1 instrument panel register assembly as shown in the illustration.

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. for Manual Tilt and Manual Telescopic Steering Column:


      1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

    2. B000MKZ

      Using a moulding remover, disengage the 4 clips and 2 guides.

    3. for LHD:


      1. B000HY1

        Disengage the 3 claws, 7 clips and 4 guides.

    4. for RHD:


      1. B000HJQ

        Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.

    5. Disconnect each connector.

    6. B000KKH

      Remove the instrument cluster finish panel assembly as shown in the illustration.

  9. REMOVE HEADLIGHT LEVELING SWITCH (for LHD)


    1. B000M8P

      Disengage the 2 claws and remove the headlight leveling switch.

  10. REMOVE HEADLIGHT LEVELING SWITCH (for RHD)


    1. B000N1O

      Disengage the 2 claws and remove the headlight leveling switch.