QUARTER WINDOW GLASS(for Hatchback) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  2. REMOVE REAR FLOOR MAT ASSEMBLY

    Click here

  3. REMOVE REAR DECK FLOOR BOX (w/ Deck Floor Box)

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/ Deck Floor Box)

    Click here

  5. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim)

    Click here

  6. REMOVE REAR DECK TRIM COVER

    Click here

  7. REMOVE REAR SEAT ASSEMBLY

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  9. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  10. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

    Click here

  11. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  12. REMOVE NO. 2 DECK SIDE TRIM HOOK

    Click here

  13. REMOVE LOWER DECK TRIM SIDE BOARD LH (w/ Deck Board)

    Click here

  14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  15. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click here

  16. REMOVE QUARTER WINDOW ASSEMBLY


    1. A01M1RKC02
      A01M1XR Protective Tape

      Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.

    2. A01M1HOC03
      *1 Clip
      *a Piano Wire

      Pass a piano wire between the vehicle body and quarter window assembly from the interior.

      Note

      Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.

    3. Tie both wire ends to wooden blocks or similar objects that can serve as handles.

    4. Cut off the adhesive by pulling the piano wire around the quarter window assembly.

      Note

      When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.

    5. A01LV4W

      Using suction cups, disengage the 3 clips and remove the quarter window assembly.

      Note


      • Be careful not to drop the quarter window assembly.

      • Be sure to replace the quarter window assembly with a new one.

  17. CLEAN VEHICLE BODY


    1. A01M0ZXC03
      *a Vehicle Body
      A01M1XR Adhesive

      Clean and shape the contact surfaces of the vehicle body.

      Standard Dimension
      Area Dimension
      a 1.0 mm (0.0394 in.) or more

      1. Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.

        Note

        Be careful not to damage the vehicle body.

        Tech Tips

        Leave as much adhesive on the vehicle body as possible.

    2. Clean the contact surfaces of the vehicle body with a piece of cloth saturated with non-residue solvent.

      Tech Tips

      Even if all the adhesive has been removed, clean the vehicle body.