POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)

DESCRIPTION

If a door glass or a door window regulator assembly does not operate smoothly, the jam protection function may be triggered automatically, resulting in the auto up function being unable to fully close the window.

CAUTION / NOTICE / HINT

Note


  • If a door window regulator assembly has been replaced with a new one, initialize the power window control system.

    Click here

  • If a door window regulator assembly has been removed and installed, or if a door window regulator assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

    Click here

Tech Tips

This symptom may occur for any of the windows.

PROCEDURE


  1. PERFORM INITIALIZATION (APPLICABLE LOCATION)


    1. Initialize the door window regulator assembly (applicable location).

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION))


    1. Check that each power windows moves when the auto up and down function of the power window regulator master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly is operated.

      Click here

      OK
      Auto up and down function is normal (applicable location).
      Result
      Proceed to
      OK
      NG

    OK

    END (PROBLEM DUE TO INITIALIZATION FAILURE)

    NG

  3. CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)


    1. Remove the window regulator.

    2. Install the window glass to the door glass run.

    3. Check if the door window regulator operates smoothly.

    4. Check that the window glass slides smoothly when sliding it up by hand.

      CAUTION:

      Perform initialization again.

      Tech Tips


        Ensure the following:

      • The window glass fits with the glass run without improper contact or deformation.

      • Foreign matter is not caught in the glass run.

      OK
      Door window glass slides smoothly.
      Result
      Result Proceed to
      OK (Driver door power window) A
      OK (Front passenger door power window)
      OK (Rear LH door power window) B
      OK (Rear RH door power window)
      NG C

    A

    REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY (FOR DRIVER DOOR OR PASSENGER DOOR) Click here

    B

    REPLACE REAR DOOR WINDOW REGULATOR ASSEMBLY (FOR LH DOOR OR RH DOOR) Click here

    C

    FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)