IMMOBILISER SYSTEM(w/ Entry and Start System), Diagnostic DTC:B279C, B279C95

DTC Code DTC Name
B279C Theft Deterrent System Presence Detection
B279C95 Engine Immobiliser System Incorrect Assembly

DESCRIPTION

If an ECM that is incompatible with the immobiliser system is installed, the ECM stores this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Note
B279C Theft Deterrent System Presence Detection An ECM that is incompatible with the immobiliser system is installed (1-trip detection logic*). ECM

DTC output confirmation operation:


  • Check for DTCs.
B279C95 Engine Immobiliser System Incorrect Assembly An ECM that is incompatible with the immobiliser system is installed (1-trip detection logic*). ECM

DTC output confirmation operation:


  • Check for DTCs.

Vehicle Condition and Fail-safe Function when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Function when Malfunction Detected
Engine cannot be started -
Related Data List and Active Test
DTC No. Data List and Active Test

  • B279C*1

  • B279C95*2

 -

CAUTION / NOTICE / HINT

Note


  • When using the GTS with the engine switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

  • After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation."

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs
      Powertrain > Engine and ECT > Clear DTCs
      Powertrain > Engine > Trouble Codes
      Result
      Proceed to
      NEXT

    NEXT

  2. CHECK FOR DTC


    1. Check for DTCs.


      Powertrain > Engine and ECT > Trouble Codes
      Powertrain > Engine and ECT > Trouble Codes
      Powertrain > Engine > Trouble Codes

      Tech Tips

      Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

      OK
      B279C*1 or B279C95*2 is not output.
      Result
      Result Proceed to
      DTC B279C*1 or B279C95*2 is not output A
      DTC B279C*1 or B279C95*2 is output B

      • *1: except 8NR-FTS

      • *2: for 8NR-FTS


    A

    USE SIMULATION METHOD TO CHECK Click here

    B

  3. REPLACE CURRENT ECM WITH PROPER ECM


    1. Replace the current ECM with the proper ECM.

      for 1ND-TV: Click here

      for 1NR-FE: Click here

      for 1ZR-FAE: Click here

      for 1ZR-FE: Click here

      for 2ZR-FE: Click here

      for 1WW: Click here

      for 8NR-FTS: Click here

      Result
      Proceed to
      NEXT

    NEXT

    END