PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
If the ECM has been struck or dropped, replace it.
Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
REMOVE AIR CLEANER CASE SUB-ASSEMBLY
SEPARATE NO. 1 AIR CLEANER INLET
Remove the bolt and separate the No. 1 air cleaner inlet.
REMOVE ECM
Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.
Note
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
Remove the 2 bolts and disengage the guide to remove the ECM.
Note
If the ECM has been struck or dropped, replace it.
REMOVE NO. 1 ECM BRACKET
Remove the 2 screws and No. 1 ECM bracket from the ECM.
REMOVE NO. 2 ECM BRACKET
Remove the 2 screws and No. 2 ECM bracket from the ECM.