POWER STEERING SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use these procedures to troubleshoot the power steering system.

  • *: Use the GTS.

PROCEDURE


  1. POWER STEERING SYSTEM

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE

    Standard Voltage
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    Result
    Proceed to
    NEXT

    NEXT

  3. CHECK DTC AND FREEZE FRAME DATA*

    Tech Tips

    Refer to DTC Check / Clear.

    Click here


    Chassis > EMPS > Trouble Codes
    Result
    Proceed to
    NEXT

    NEXT

  4. POWER STEERING SYSTEM

    Result
    Result Proceed to
    Symptom does not occur. A
    Symptom occurs. B

    B

    GO TO STEP 6 Click here

    A

  5. SYMPTOM SIMULATION

    Result
    Proceed to
    NEXT

    NEXT

  6. CHECK CAN COMMUNICATION SYSTEM*


    1. Check for DTCs.

      w/ Central Gateway ECU: Click here

      w/o Central Gateway ECU: Click here

      Result
      Result Proceed to
      CAN communication system DTCs are not output. A
      CAN communication system DTCs are output. B

      Tech Tips


      • If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

      • If communication to the power steering ECU assembly cannot be established through the GTS, inspect terminals CANH and CANL of the DLC3 and the power steering ECU assembly, and the IG circuit of the power steering ECU assembly.


    B

    PROCEED TO CAN COMMUNICATION SYSTEM w/ Central Gateway ECU: Click here
    PROCEED TO CAN COMMUNICATION SYSTEM w/o Central Gateway ECU: Click here

    A

  7. CHECK FOR DTC*


    1. Check for DTCs.

      Click here


      Chassis > EMPS > Trouble Codes

      Tech Tips

      Refer to Diagnostic Trouble Code Chart when any DTCs are output.

      Click here

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    B

    GO TO STEP 10 Click here

    A

  8. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table.

      Click here

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table. A
      Fault is listed in Problem Symptoms Table. B

    B

    GO TO STEP 10 Click here

    A

  9. POWER STEERING SYSTEM


    1. Refer to Terminals of ECU.

      Click here

    2. Refer to Data List / Active Test.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  10. REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  11. POWER STEERING SYSTEM

    Result
    Proceed to
    NEXT

    NEXT

    END