REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR WHEEL

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    for Sedan: Click here

    for Hatchback, Wagon: Click here

  5. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click here

  6. REMOVE PARKING BRAKE LEVER PROTECTOR (for Double Wishbone Type Suspension)

    Click here

  7. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    for Torsion Beam Type Suspension: Click here

    for Double Wishbone Type Suspension: Click here

  8. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    for Torsion Beam Type Suspension: Click here

    for Double Wishbone Type Suspension: Click here

  9. REMOVE REAR DISC

    Click here

  10. DISCONNECT SKID CONTROL SENSOR WIRE (for Torsion Beam Type Suspension)


    1. B0042BO

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note

      Be careful not to damage the rear speed sensor.

  11. DISCONNECT SKID CONTROL SENSOR WIRE (for Double Wishbone Type Suspension)


    1. B004462

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note

      Be careful not to damage the rear speed sensor.

  12. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. Remove the rear axle hub and bearing assembly.

      for Torsion Beam Type Suspension: Click here

      for Double Wishbone Type Suspension: Click here

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.