REAR AXLE HUB(for Torsion Beam Type Suspension) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

  2. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  3. LOOSEN NO. 2 WIRE ADJUSTING NUT

    Click here

  4. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  5. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. REMOVE REAR DISC

    Click here

  7. INSPECT REAR AXLE HUB BEARING LOOSENESS


    1. A00Y9CP

      Using a dial indicator, check for looseness near the center of the rear axle hub.

      Maximum Looseness
      0.05 mm (0.00196 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

      Tech Tips

      If the looseness exceeds the maximum, replace the rear axle hub and bearing assembly.

  8. INSPECT REAR AXLE HUB RUNOUT


    1. A00Y810

      Using a dial indicator, check for runout on the surface of the rear axle hub outside the rear axle hub bolts.

      Maximum Runout
      0.07 mm (0.00275 in.)

      Note


      • Ensure that the dial indicator is set perpendicular to the measurement surface.

      • Make sure to install the tip of the dial indicator towards the outside of the rear axle hub bolts.

      • Keep the magnet of the dial indicator away from the rear axle hub and bearing assembly.

      Tech Tips

      If the runout exceeds the maximum, replace the rear axle hub and bearing assembly.

  9. INSTALL REAR DISC

    Click here

  10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  11. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  12. ADJUST PARKING BRAKE

    Click here

  13. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

    Click here

  14. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }