TRANSMISSION CONTROL CABLE

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

Pass the transmission control cable assembly into the vehicle and install the transmission control cable assembly to the body using the 2 nuts.

Torque:

5.0 N*m { 51 kgf*cm, 44 in.*lbf }
Install the transmission control cable assembly to the rear engine mounting insulator with the bolt.

Torque:

5.0 N*m { 51 kgf*cm, 44 in.*lbf }
Install the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
*a P Position

*b N Position

Turn the lever clockwise until it stops, then turn it counterclockwise 2 notches.
Install the transmission control cable assembly onto the control shaft lever with the nut.

Torque:

12 N*m { 122 kgf*cm, 9 ft.*lbf }

Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

*1	Stopper	*2	Nut
*a	Push in	-	-

Install the outer part of the transmission control cable assembly to the shift lever assembly. Check that the spring is positioned at "A" and push in the stopper.

*1	Shift Lever Assembly	*2	Stopper
*3	Spring	*4	Nut
*a	Push in	-	-

Note

If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.
Make sure that the transmission control cable assembly is securely locked.

Install the end of the transmission control cable assembly to the shift lever assembly.
Note
- Install the end of the transmission control cable assembly all the way to the base of the pin.
- Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.