MANUAL TRANSAXLE OIL REPLACEMENT

PROCEDURE


  1. REMOVE NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  2. REMOVE NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here

  3. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  4. DRAIN MANUAL TRANSAXLE OIL


    1. B00423TC03
      *1 Manual Transmission Filler Plug
      *2 Manual Transmission Drain Plug

      Remove the manual transmission filler plug and gasket.

    2. Using a 10 mm hexagon socket wrench, remove the manual transmission drain plug and gasket to drain the manual transaxle oil.

    3. Using a 10 mm hexagon socket wrench, install a new gasket and the manual transmission drain plug.

      Torque:
      45 N*m  { 459 kgf*cm, 33 ft.*lbf }

  5. ADD MANUAL TRANSAXLE OIL


    1. B0041V3C02
      *a 0 to 5 mm

      Add manual transaxle oil until the oil level is between 0 and 5 mm (0.197 in.) from the bottom lip of the manual transmission filler plug opening.

      Manual Transmission Oil
      "Toyota Genuine Manual Transmission Gear Oil LV GL-4 and SAE 75W"or "API GL-4 and SAE 75W"
      Standard Capacity
      2.4 liters (2.5 US qts, 2.1 Imp.qts.)

    2. Install a new gasket and the manual transmission filler plug.

      Torque:
      39.2 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note


      • When adding manual transaxle oil, make sure that the vehicle is level.

      • An excessively large or small amount of manual transaxle oil may cause problems.

      • After adding manual transaxle oil, drive the vehicle and recheck the oil level.

  6. INSPECT FOR OIL LEAK

  7. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  8. INSTALL NO. 1 ENGINE UNDER COVER (for Half Cover Type)

    Click here

  9. INSTALL NO. 1 ENGINE UNDER COVER (for Full Cover Type)

    Click here