CLUTCH SYSTEM(for EC65A) PRECAUTION


  1. PRECAUTION REGARDING ON-VEHICLE INSPECTION


    1. When racing the engine, make sure that the gear is in neutral.

  2. PRECAUTION REGARDING PARTS INSTALLATION


    1. When installing parts related to the multi-mode manual transmission system, perform Clamp Position Adjustment, Initialization and Learning and/or Synchronization Position Calibration. In addition, the required operations differ according to the parts to be installed. Proceed with the operation in the order shown in the table below.

      After Installation
      Parts Installed Operation Order See Procedure

      • Transmission assembly

      • Transmission parts (inside gear box)

      • TCM

      • Clutch actuator

      • Clutch disc and clutch cover

      • Clutch release with bearing cylinder assembly

      • Flywheel

      • Crankshaft

      • Clutch fluid

      1. Initialization of multi-mode manual transmission system

      [Initialization of ECU]

      Click here

      2. Learning of multi-mode manual transmission system

      Click here

      3. Synchronization position calibration

      Click here


      • Shift and select actuator

      • Shift stroke sensor

      • Select stroke sensor

      1. Initialization of multi-mode manual transmission system

      [Initialization of transmission]

      Click here

      2. Learning of multi-mode manual transmission system

      Click here

      3. Synchronization position calibration

      Click here


      • Clutch stroke sensor

      1. Initialization of multi-mode manual transmission system

      [Initialization of clutch]

      Click here

      2. Learning of multi-mode manual transmission system

      Click here

      Note


      • After replacing any system components, perform initialization and learning of related components (refer to the operations listed above). If initialization and learning are not performed, the transmission system will not function properly.

      • Before proceeding with learning of the multi-mode manual transmission system, clear (initialize) the previously stored learned values. Since the multi-mode manual transmission system does not have an overwrite function, clearing (initializing) stored data is necessary to perform learning of the system.