SPEED LIMITER SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the speed limiter system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT BATTERY VOLTAGE


    1. Measure the battery voltage with the ignition switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)


    1. Using the GTS, check if the CAN communication system is functioning normally.

      Result
      Result Proceed to
      CAN DTCs are not output A
      CAN DTCs are output B

    B

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  4. CHECK VEHICLE CONDITION


    1. Choose the model to be inspected.

      Result
      Result Proceed to
      except 8NR-FTS, 1ND-TV, 1WW A
      8NR-FTS, 1ND-TV, 1WW B

    B

    CHECK FOR DTC* Click here

    A

  5. PROBLEM SYMPTOMS TABLE

    Refer to Problem Symptoms Table.

    Click here

    Result
    Result Proceed to
    Fault is not listed in Problem Symptoms Table A
    Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 7 Click here

    A

  6. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Operation Check

      Click here

    2. Terminals of ECU

      Click here

    3. Data List / Active Test

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  7. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  8. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END

  9. CHECK FOR DTC*

    Refer to DTC Check / Clear.

    Click here


    1. Check for DTCs and note any codes that are output.

    2. for 8NR-FTS:

      Clear the DTCs.


      Powertrain > Engine > Clear DTCs

    3. for 8NR-FTS:

      Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.


      Powertrain > Engine > Trouble Codes

    4. for 1ND-TV:

      Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs

    5. for 1ND-TV:

      Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.


      Powertrain > Engine and ECT > Trouble Codes

    6. for 1WW:

      Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs

    7. for 1WW:

      Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.


      Powertrain > Engine and ECT > Trouble Codes
      Result
      Result Proceed to
      DTC does not reoccur A
      DTC reoccurs B

    A

    GO TO STEP 5 Click here

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART Click here