DIFFERENTIAL PRESSURE SENSOR(w/ Glow Plug Controller) REMOVAL

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  3. REMOVE WATER GUARD PLATE LH


  4. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL


  5. REMOVE OUTER COWL TOP PANEL


  6. REMOVE NO. 1 WIRE HARNESS HEAT INSULATOR

    Click here

  7. REMOVE WIRE HARNESS CLAMP BRACKET

    Click here

  8. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY


    1. B004223

      Disconnect the differential pressure sensor assembly connector.

    2. B004550

      Disengage the clamp to disconnect the engine wire from the sensor bracket.

    3. B00421U

      Disengage the snap fastener and turn back the No.2 wire harness heat insulator.

    4. B0042MK

      Disengage the guide to remove the No. 2 wire harness heat insulator from the differential pressure sensor assembly.

    5. B0043Y3

      Slide the clip and disconnect the No. 1 vacuum transmitting hose assembly from the differential pressure sensor assembly.

    6. B0044B0

      Slide the clip and disconnect the No. 2 vacuum transmitting hose assembly from the differential pressure sensor assembly.

    7. B0044CE

      Remove the bolt and differential pressure sensor assembly from the sensor bracket.