FUEL INJECTOR(w/ Glow Plug Controller) REMOVAL

CAUTION / NOTICE / HINT

Note


  • When replacing the injector assemblies (including exchanging the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipe sub-assemblies with new ones.

  • When replacing the injector assemblies, supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.

Tech Tips

After replacing any of the injector assemblies, perform both the "Injector Compensation" and the "Pilot Quantity Learning Values Reset" functions using the GTS.

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  3. REMOVE NO. 1 GLOW PLUG CONNECTOR

    Click here

  4. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

    Click here

  5. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY

    Click here

  6. REMOVE NO. 1 INJECTION PIPE SUB-ASSEMBLY

    Click here

  7. REMOVE NO. 2 INJECTION PIPE SUB-ASSEMBLY

    Click here

  8. REMOVE NO. 3 INJECTION PIPE SUB-ASSEMBLY

    Click here

  9. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

    Click here

  10. REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY

    Click here

  11. REMOVE NO. 1 NOZZLE HOLDER CLAMP


    1. B004459

      Remove the 4 bolts.

    2. B00450F

      Remove the 4 washers from the No. 1 nozzle holder clamps.

    3. B0042DK

      Remove the 4 No. 1 nozzle holder clamps from the injector assemblies and nozzle holder clamp seats.

  12. REMOVE NOZZLE HOLDER CLAMP SEAT


    1. B0044R5

      Remove the 4 nozzle holder clamp seats from the cylinder head sub-assembly.

  13. REMOVE INJECTOR ASSEMBLY


    1. B004366

      Remove the 4 injector assemblies from the cylinder head sub-assembly.

      Note


      • Each injector assembly has its own fuel injection part number. When replacing the injector assemblies, store them in the correct order so that they can be returned to their original locations when reassembled.

      • Arrange the injector assemblies, No. 1 nozzle holder clamps, washers, bolts and nozzle holder clamp seats in the correct order.

  14. REMOVE INJECTION NOZZLE SEAT


    1. B0043KC

      Remove the 4 injection nozzle seats from the injector assemblies or cylinder head sub-assembly.

      Note

      When removing the injector assembly, check that the injection nozzle seat is either attached to the injector assembly, or remains in the cylinder head sub-assembly.