STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

      Click here

    • When the starter assembly is replaced, "starter relay assembly" must be also replaced.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A01LWIT

      Disengage the claw by pulling the flywheel housing side cover outward and remove the flywheel housing side cover.

  6. REMOVE STARTER ASSEMBLY


    1. A01LW1M

      Disengage the 2 clamps.

    2. A01LWC4

      Open the terminal cap.

    3. Remove the nut and disconnect terminal 30.

    4. Disconnect the connector.

    5. A01M0HI

      Remove the 2 bolts and starter assembly.