ECM REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE NO. 1 ENGINE COVER

    Click here

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  6. SEPARATE NO. 1 AIR CLEANER INLET


    1. B00447N

      Remove the bolt.

  7. REMOVE ECM


    1. B0043XQ

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

    2. Disengage the wire harness clamp.

    3. B0044K5

      Remove the 2 bolts, clamp and the ECM with ECM brackets.

      Note


      • If a component has been dropped or subjected to a strong impact, replace it.

      • After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

  8. REMOVE NO. 1 ECM BRACKET


    1. B00453T

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  9. REMOVE NO. 2 ECM BRACKET


    1. B0043QJ

      Remove the 2 screws and No. 2 ECM bracket from the ECM.