REPAIR INSTRUCTION INITIALIZATION


  1. PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED

    Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
    Memorize maximum steering angle Simple intelligent parking assist system

    Click here

    Operate Back door lock Power door lock control system (for Hatchback, Wagon)

    Click here

    Drive the vehicle until stop and start control is permitted (approximately 5 to 40 minutes) Stop and start system

    Click here

    Note


    • for Sedan Radio and Display Type:

      After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 80*1 or 120*2 seconds before disconnecting the cable from the negative (-) battery terminal.

      *1: w/ DVD Player

      *2: w/o DVD Player

    • except Sedan Radio and Display Type:

      After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.

    • for Navigation System:

      After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED

    Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link
    ECM

    1. Learning values save

    2. Learning values write

    • Warning light comes on

    • Deterioration of fuel efficiency

    Click here for 1ND-TV*9 Precaution

    Click here for 1ND-TV*9 Initialization

    Click here for 1ND-TV*9 Registration
    Injector assembly

    • Injector compensation

    • Pilot quantity learning values reset

    • Warning light comes on

    • Deterioration of fuel efficiency
    DPF catalyst DPF deterioration record clear

    • Warning light comes on

    • Deterioration of fuel efficiency
    Air fuel ratio sensor A/F sensor compensation reset

    • Warning light comes on

    • Deterioration of fuel efficiency
    Engine assembly

    • Injector compensation

    • Pilot quantity learning values reset

    • Warning light comes on

    • Deterioration of fuel efficiency

    • Diesel throttle body assembly

    • Electric EGR control valve assembly

    • Turbocharger sub-assembly

    		 ECD system initialization Engine start function

    • Throttle body with motor assembly

    • Cleaning the deposits from the throttle body with motor assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft

      (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • No. 1 ignition coil

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair

    • Poor idle, etc.

    • Engine start function, etc.

    Click here for 1NR-FE
    Piston ring Clear heavy knock history -

    Click here for 8NR-FTS

    • Throttle body with motor assembly

    • Cleaning the deposits from the throttle body with motor assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump (for low pressure side)

    • Fuel pump (for high pressure side)

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair

    • Poor idle, etc.

    • Engine start function, etc.

    • Throttle body assembly

    • Cleaning the deposits from the throttle body assembly

    • Engine assembly

    • Continuously variable valve lift controller assembly

    • Cylinder head sub-assembly

    • Camshaft housing sub-assembly

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair

    • Poor idle, etc.

    • Engine start function, etc.

    Click here for 1ZR-FAE

    • Throttle body assembly

    • Cleaning the deposits from the throttle body assembly

    • Engine assembly

    • Cylinder head sub-assembly

    • Camshaft (for intake or exhaust camshaft)

    • Camshaft timing gear assembly

    • Camshaft timing exhaust gear assembly

    • Piston or piston ring

    • Mass air flow meter sub-assembly

    • Fuel injector assembly

    • Fuel pump

    • Air fuel ratio sensor

    • Engine coolant temperature sensor

    • Spark plug

    • Ignition coil assembly

    • Air leaks from intake system

    • Gas leaks from exhaust system

    • Knock control sensor

    		 Inspection after repair

    • Poor idle, etc.

    • Engine start function, etc.

    Click here for 1ZR-FE

    Click here for 2ZR-FE
    ECM

    • Learning values save

    • Learning values write

    		 -

    Click here for 1WW
    Injector assembly Injector compensation
    Fuel supply pump assembly Supply pump learning value reset
    Exhaust manifold converter sub-assembly (catalytic converter)

    • DPF history information reset

    • NOx storage catalyst learning value reset
    Air fuel ratio sensor O2 sensor learning value reset
    Mass air flow meter Air flow meter learning value reset
    EGR valve assembly EGR learning value reset
    Differential pressure sensor Differential pressure learning value reset
    Swirl control valve Swirl valve learning value reset
    Pressure discharge valve Fuel PCV compensation value reset
    Turbo pressure sensor assembly Upstream turbine pressure learning value reset
    Engine assembly Injector compensation
    Pre-crash safety city sensor

    1. Recognition camera/target position memory

    2. Recognition camera axis adjust

    • Lane departure alert system

    • Road Sign Assist System

    • Pre-crash safety system

    Click here

    Engine stop and start ECU*10

    1. Upload the number of starter operations

    2. Reset air conditioning information

    3. Learning of air conditioning information

    4. Clear the zero point calibration data

    5. Perform zero point calibration of the deceleration sensor

    		 Stop and start system

    Click here

    Air conditioning amplifier assembly*10

    1. Reset air conditioning information

    2. Learning of air conditioning information

    Starter assembly*10

    Note

    When the starter assembly is replaced, "ST NO. 1 relay" must be also replaced.

    		 Clear the number of starter operations
    Airbag sensor assembly*10

    1. Clear the zero point calibration data

    2. Perform zero point calibration of the deceleration sensor

    • Continuously variable transaxle assembly*10

    • CVT fluid*10

    		 Bleed the oil pump assembly with motor
    Battery*10

    • Clear the integrated current value

    • Switch battery type

    • Transaxle assembly

    • Transaxle parts (inside gear box)

    • TCM

    • Clutch actuator assembly

    • Clutch disc and clutch cover

    • Clutch release with bearing cylinder assembly

    • Flywheel

    • Crankshaft

    • Shift and select actuator

    • Shift stroke sensor

    • Select stroke sensor

    1. Initialization and learning of multi-mode manual transaxle system

    2. Synchronization position calibration

    		 Multi-mode manual transaxle system

    Click here for Initialization

    Click here for Calibration
    Clutch stroke sensor Initialization and learning of multi-mode manual transaxle system Multi-mode manual transaxle system

    • Continuously variable transaxle assembly

    • ECM

    • Oil pressure sensor

    • Airbag sensor assembly (Yaw rate and acceleration sensor)

    1. Reset memory

    2. Deceleration sensor zero point calibration

    3. CVT oil pressure calibration

    		 Deterioration of fuel efficiency

    Click here for K311

    Click here for K313*1

    Click here for K313*2
    CVT fluid*2 Perform ATF thermal degradation estimate reset -

    Click here


    • Tire pressure warning ECU and receiver

    • Tire pressure warning valve and transmitter

    • Transmitter ID registration

    • Initialization

    • When DTC detection conditions of "transmitter ID not received" are met, TPWS indicator blinks for 1 minute, and then illuminates

    • Tire pressure warning function

    Click here for Initialization

    Click here for Registration
    Skid control ECU (Brake actuator assembly) (w/ VSC) Perform system variant learning

    • Slip indicator light illuminated

    • DTC C1288 (Error in Matching of ECUs) stored

    Click here

    Power steering ECU assembly

    • Torque sensor zero point calibration

    • Assist map writing

    • EPS warning light illuminated

    • EPS control

    Click here

    Electric power steering column sub-assembly Torque sensor zero point calibration Steering effort different between turning steering wheel left and right
    Telematics transceiver*11 Register vehicle information Emergency call service

    Click here

    Mobilephone battery*11 Reset mobilephone battery condition

    • Spiral cable with sensor sub-assembly*12

    • Clearance warning ECU assembly*12

    		 Initialize simple intelligent parking assist system Simple intelligent parking assist system

    Click here

    ECM Vehicle Identification Number (VIN) or frame number registration

    • MIL comes on

    • DTCs are output

    Click here for 1ND-TV*9

    Click here for 1NR-FE

    Click here for 8NR-FTS

    Click here for 1ZR-FAE

    Click here for 1ZR-FE

    Click here for 2ZR-FE

    Click here for 1WW
    Heavy Knock History -

    Click here for 8NR-FTS
    ECU communication ID registration (Immobiliser system) Engine start See Service Bulletin for the registration method.

    • Certification ECU (smart key ECU assembly)*3

    • Steering lock ECU (steering lock actuator assembly)*3

    • Electrical key transmitter sub-assembly*3

    • ID code box (immobiliser code ECU)

    		 Code registration (Immobiliser system)

    • Wireless door lock control system

    • Entry and Smart System

    • Engine start

    • Steering lock system

    • Transponder key ECU assembly*4

    • Key*4

    		 Code registration (Immobiliser system) Engine start

    • Door control transmitter assembly*4

    • Door control receiver

    		 Code registration (Wireless door lock system) Wireless door lock control system

    Click here


    • Air mix damper servo sub-assembly (for driver side)*7

    • Air mix damper servo sub-assembly (for front passenger side)*7

    • Air mix damper servo sub-assembly*8

    • Mode damper servo sub-assembly

    • Recirculation damper servo sub-assembly

    		 Initialization servo motor (for Automatic air conditioning system) DTCs are output

    Click here


    • Roof sunshade ECU (sliding roof drive gear assembly)

    • Sliding roof housing sub-assembly

    		 Initialize roof sunshade system

    • Auto open and close Function

    • Jam protection function

    Click here


    • Front door window regulator assembly (for driver door)*6

    • Door window regulator sub-assembly*5

    • Door glass

    • Door glass run

    		 Initialize power window control system

    • Auto up and down function

    • Jam protection function

    • Remote control function*5

    • Key-off operation function

    Click here*5

    Click here*6

    • Headlight leveling ECU assembly*13

    • Rear height control sensor sub-assembly*13

    		 Perform headlight leveling ECU assembly initialization Automatic headlight beam level control system

    Click here


    • Headlight swivel ECU assembly*14

    • Rear height control sensor sub-assembly*14

    		 Perform headlight swivel ECU assembly initialization Automatic headlight beam level control system

    Click here


    • *1: for 8NR-FTS

    • *2: for 1ZR-FAE

    • *3: w/ Entry and Start System

    • *4: w/o Entry and Start System

    • *5: for Models with Jam Protection Function on 4 Windows

    • *6: for Models with Jam Protection Function on Driver Door Window Only

    • *7: for Dual Type

    • *8: for Single Type

    • *9: w/ Glow Plug Controller

    • *10: w/ Stop and Start System

    • *11: w/ Manual (SOS) Switch

    • *12: w/ Simple Intelligent Parking Assist System

    • *13: for Sedan

    • *14: except Sedan