OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

    A01LWT0C01
    *a Adhesive

    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
    2. A01M2NOC02
      *a 27 mm Deep Socket Wrench

      Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the oil pressure sender gauge assembly connector.

  2. INSPECT FOR OIL LEAK

    Click here

  3. INSTALL REAR ENGINE UNDER COVER RH

  4. INSTALL NO. 1 ENGINE UNDER COVER