GLOW PLUG(w/ Glow Plug Controller) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  3. WARM UP ENGINE

    Note

    The glow plug assembly may be damaged if it is removed before the engine is warmed up.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. B0042DR

      Disconnect the No. 1 glow plug connector connector.

    2. Disengage the clamp.

    3. B00447K

      Remove the 4 glow plug screw grommets from the glow plug assemblies.

    4. B0042OH

      Remove the 4 nuts and No. 1 glow plug connector from the glow plug assemblies.

  6. REMOVE GLOW PLUG ASSEMBLY


    1. B0042RE

      Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

      Note

      Do not remove the glow plug assemblies before the engine is warmed up.