HIGH INTENSITY DISCHARGE HEADLIGHT BULB INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. INSTALL DISCHARGE HEADLIGHT BULB

    A002N19E02

    1. Set the discharge headlight bulb to the headlight unit.

    2. Lock the set spring in the order shown in the illustration to install the discharge headlight bulb to the headlight unit.

      Note

      Do not touch the discharge headlight bulb glass.

  2. INSTALL HEADLIGHT GASKET


    1. Install a new headlight gasket to the headlight light control ECU sub-assembly LH.

  3. INSTALL HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH

    A002O1A

    1. Turn the headlight light control ECU sub-assembly socket in the direction indicated by the arrow in the illustration to connect the headlight light control ECU sub-assembly socket.

      Note


      • Check that the headlight gasket is installed on the headlight light control ECU sub-assembly LH.

      • Check that the headlight gasket is not damaged or contaminated with foreign matter. If there is any damage, replace the headlight gasket with a new one.

      • Do not pull the headlight light control ECU sub-assembly LH with the socket connected.

    2. A002MVA

      Turn the headlight light control ECU sub-assembly LH in the direction indicated by the arrow in the illustration to install the headlight light control ECU sub-assembly LH to the headlight unit.

    3. Connect the connector.

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL FRONT BUMPER COVER

    Click here