AIR FUEL RATIO SENSOR(for Sensor 1) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR


    1. A002Q0YE02
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the air fuel ratio sensor.

      SST
      09224-00011
      Torque:
      without SST
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }
      with SST
      45 N*m  { 463 kgf*cm, 33 ft.*lbf }

      Note

      If an air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

      • Make sure SST and the wrench are connected in a straight line.

      • Perform "Inspection After Repairs" after replacing the air fuel ratio sensor Click here.

    2. A002M6FE01
      Text in Illustration
      *1 Air Fuel Ratio Sensor Connector
      *2 Bracket
      *a 1.5 mm (0.0591 in.) or less

      Lower the air fuel ratio sensor connector to the position shown in the illustration and connect the air fuel ratio sensor connector.

    3. Attach the 2 clamps.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. INSTALL NO. 1 ENGINE COVER

    Click here

  4. PERFORM AIR FUEL RATIO SENSOR INITIALIZATION

    Click here