EXHAUST GAS TEMPERATURE SENSOR(for Sensor 1) INSTALLATION

PROCEDURE


  1. INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1)

    Note

    If the exhaust gas temperature sensor is dropped, replace it with a new one.


    1. Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

      Torque:
      30 N*m  { 306 kgf*cm, 22 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

  2. INSTALL NO. 1 TURBO INSULATOR


    1. Install the No. 1 turbo insulator with the 3 bolts and nut.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  3. CONNECT VACUUM CONTROL VALVE BRACKET


    1. Using a T20 "TORX" socket wrench, connect the vacuum control valve bracket with the 3 screws.

    2. Attach the air fuel ratio sensor clamp to the vacuum control valve bracket.

    3. A002QUQE02
      Text in Illustration
      *1 Vacuum Control Valve Bracket
      *a 1.5 mm (0.0591 in.) or less
      *b Air Fuel Ratio Sensor Connector Wire
      *c Exhaust Gas Temperature Sensor Connector Wire
      *d Air Fuel Ratio Sensor Connector

      Move the clamp as shown in the illustration, and secure the air fuel ratio sensor and exhaust gas temperature sensor with the clamp.

      Note

      The wire harness may become damaged if not installed when the clamp is open.

    4. Lower the air fuel ratio sensor connector to the position shown in the illustration.

    5. Connect the air fuel ratio sensor connector.

    6. Connect the exhaust gas temperature sensor connector.

    7. Attach the wire harness clamp.

    8. Connect the exhaust gas temperature sensor connector.

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here

  5. INSTALL NO. 1 ENGINE COVER

    Click here