OIL COOLER REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System for HDD:

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  4. REMOVE BATTERY

  5. REMOVE BATTERY TRAY

  6. DISCONNECT RADIATOR PIPE


    1. A002QXQ

      Remove the 2 bolts and disconnect the radiator pipe from the battery carrier.

  7. REMOVE BATTERY CARRIER

    Click here

  8. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  9. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  10. DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

    Click here

  11. DRAIN ENGINE COOLANT

    Click here

  12. DISCONNECT WATER BY-PASS HOSE


    1. A002OL8

      Slide the 2 clips and disconnect the water by-pass hose from the transmission oil cooler.

  13. REMOVE TRANSMISSION OIL COOLER


    1. A002QJG

      Remove the 3 bolts and transmission oil cooler from the continuously variable transaxle assembly.

    2. Remove the 2 O-rings from the transmission oil cooler.