FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedures listed below are for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY

    B00192B

    1. Align the anchor plate positioning hole with the claw, and install the anchor plate with the 2 bolts.

      Tech Tips

      First install the lower bolt, and then install the upper bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY

    B001A4DE01

    Note

    When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


    1. Align the claws of the vehicle with the seat belt retractor positioning holes.

    2. Install the seat belt with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }
    3. B001964E01

      Connect the pretensioner connector labeled A as shown in the illustration.

    4. Connect the tension reducer connector labeled B.

    5. w/ Pre-Crash Safety System:

      Connect the pre-crash safety system connector labeled C.

    6. B0018JA

      Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH

    Click here

  4. INSTALL REAR ASSIST GRIP ASSEMBLY

    Click here

  5. INSTALL CENTER LOWER PILLAR GARNISH

    B0018U2

    Tech Tips


    • When installing the center lower pillar garnish, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.

    • After moving the front seat, disconnect the cable from the negative (-) battery terminal.


    1. Attach the 2 claws and 7 clips to install the center lower pillar garnish.

    2. B0018B6

      Install the seat belt anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  6. INSTALL CENTER PILLAR GARNISH COVER

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE

    Click here

  8. INSTALL REAR STEP COVER

    Click here

  9. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.