CAUTION / NOTICE / HINT
Tech Tips
Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart Click here.
PROCEDURE
INSTALL FRONT SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY
Align the anchor plate positioning hole with the claw, and install the anchor plate with the 2 bolts.
Tech Tips
First install the lower bolt, and then install the upper bolt.
INSTALL FRONT SEAT OUTER BELT ASSEMBLY
Note
When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.
Align the claws of the vehicle with the seat belt retractor positioning holes.
Install the seat belt with the bolt.
Connect the pretensioner connector labeled A as shown in the illustration.
Connect the tension reducer connector labeled B.
w/ Pre-Crash Safety System:
Connect the pre-crash safety system connector labeled C.
Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.
INSTALL CENTER PILLAR GARNISH
INSTALL REAR ASSIST GRIP ASSEMBLY
INSTALL CENTER LOWER PILLAR GARNISH
Tech Tips
When installing the center lower pillar garnish, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.
After moving the front seat, disconnect the cable from the negative (-) battery terminal.
Attach the 2 claws and 7 clips to install the center lower pillar garnish.
Install the seat belt anchor with the bolt.
INSTALL CENTER PILLAR GARNISH COVER
INSTALL REAR DOOR SCUFF PLATE
INSTALL REAR STEP COVER
INSTALL FRONT DOOR SCUFF PLATE
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
CHECK SRS WARNING LIGHT
Check the SRS warning light Click here.