RADIO ANTENNA CORD REMOVAL

PROCEDURE


  1. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY


    1. Remove the instrument panel safety pad Click here.

  4. REMOVE ANTENNA CORD SUB-ASSEMBLY


    1. for LHD:

      Detach the 7 clamps and remove the antenna cord.

      B001AY2

    2. for RHD:

      Detach the 8 clamps and remove the antenna cord.

      B0018T2

  5. REMOVE ROOF HEADLINING ASSEMBLY


    1. Remove the roof headlining assembly Click here.

  6. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. w/o Sliding Roof:


      1. Detach the 2 clamps and remove the antenna from the notch on the rear of the roof headlining.

        B00196K

      2. Remove the antenna cord from the roof headlining.

      3. Remove the double-sided tape from the roof headlining.

    2. w/ Sliding Roof:


      1. Detach the 2 clamps and remove the antenna from the 3 ribs and notch on the rear of the roof headlining.

        B001971

      2. Remove the antenna cord from the roof headlining.

      3. Remove the double-sided tape from the roof headlining.

  7. REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY


    1. Disconnect each connector.

      B0018UX

    2. Remove the 2 bolts and 2 brackets.

    3. Detach each clamp and remove the No. 4 antenna cord sub-assembly.