DAMPING FORCE CONTROL ACTUATOR(for Front Side) ON-VEHICLE INSPECTION

PROCEDURE


  1. REMOVE REAR QUARTER PANEL MUDGUARD RH

    Click here

  2. REMOVE FUEL TANK FILLER PIPE PROTECTOR

    Click here

  3. INSPECT FRONT SUSPENSION CONTROL ACCUMULATOR ASSEMBLY LH

    Note

    Perform the following after inspecting and adjusting the vehicle height.


    1. A01WX0B

      With the vehicle empty, start the engine and set the vehicle height to LOW.

    2. Record the reservoir tank fluid level (A).

    3. Set the vehicle height to HIGH.

      Tech Tips

      Make sure to check the fluid level approximately 30 seconds after the vehicle height changes to HIGH.

    4. Record the reservoir tank fluid level (B), and check that A minus B is within the specified value.

      Specified Value
      A - B = 5 marks or more

      • If the result is not as specified, replace all suspension control accumulators.