ACTIVE HEIGHT CONTROL PUMP AND MOTOR REMOVAL

PROCEDURE


  1. DISCHARGE SUSPENSION FLUID PRESSURE


    1. A01WPW6

      Connect a hose to the bleeder plug for the height control accumulator and loosen the bleeder plug.

    2. Discharge the suspension fluid pressure.

    3. After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }
  2. REMOVE REAR QUARTER PANEL MUDGUARD RH

    Click here

  3. REMOVE REAR BUMPER COVER


    1. for Standard:

      Remove the bumper cover Click here.

    2. w/ Towing Hitch:

      Remove the bumper cover Click here.

    3. w/ Pintle Hook:

      Remove the bumper cover Click here.

  4. REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR

    A01WWAS

    1. Remove the 2 screws, 2 grommets and protector.

  5. REMOVE FUEL TANK FILLER PIPE PROTECTOR


    1. A01WTMN

      Using a T30 "TORX" socket wrench, remove the 3 screws, 2 grommets and pipe protector.

  6. DISCONNECT REAR NO. 6 HEIGHT CONTROL TUBE


    1. A01WS7A

      Using a union nut wrench, disconnect the No. 6 height control tube from the pump and motor.

  7. REMOVE HEIGHT CONTROL TUBE CLAMP


    1. A01WPN0E01
      *1 Height Control Tube Clamp

      Disconnect the tube clamp from the hose, then remove the 2 bolts and tube clamp.

  8. REMOVE HEIGHT CONTROL PUMP AND MOTOR ASSEMBLY


    1. A01WS1G

      Disconnect the 2 connectors and 3 clamps.

    2. A01WWVU

      Remove the 3 bolts and pump and motor.