FRONT AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL FRONT AIRBAG SENSOR LH

   
   

   1. Check that the power switch is off.

   2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

   3. Insert the pin (stopper) into the body hole to install the front airbag sensor LH with the 2 bolts.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

      Note

      
      

      • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the front airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.

   4. Connect the connector to the front airbag sensor.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

      
      

      1. Before connecting the connector, check that the position of the housing lock is correct as shown in the illustration.

         

         Text in Illustration

         *a

         Incorrect

         *b

         Correct

      2. While holding the outer housing be sure to engage the connector until they are locked and check that the outer housing is in its original position (when locking, make sure that a click sound can be heard).

         

         Text in Illustration

         *1	Housing Lock	*2	Outer Housing
         *a	Connection is Completed	-	-

         Tech Tips

         When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an insecure fit.

   5. Check that there is no looseness in the installation parts of the front airbag sensor LH.

2. INSTALL HEADLIGHT ASSEMBLY

   for Single Beam Headlight: Click here

   for Triple Beam Headlight: Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. PERFORM DIAGNOSTIC SYSTEM CHECK

   Click here

5. INSPECT SRS WARNING LIGHT

   Click here

6. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

   Click here