FRONT SEAT SIDE AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Be sure to read Precaution thoroughly before servicing Click here.

  • Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

  • If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

    for Sports Seat Type: Click here

    for Luxury Seat Type: Click here

    for Standard Seat Type: Click here

Tech Tips


  • Use the same procedures for the LH side and RH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH

    for Sports Seat Type: Click here

    for Luxury Seat Type: Click here

    for Standard Seat Type: Click here

  3. REMOVE FRONT SEATBACK SUPPORT LH (for Sports Seat Type, Driver Side)

    Click here

  4. REMOVE FRONT SEATBACK SUPPORT LH (for Luxury Seat Type)

    Click here

  5. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH


    1. A000RIVE03
      Text in Illustration
      *1 Housing Lock
      *2 Outer Housing

      Disconnect the airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push the housing lock and slide the outer housing. (At this time, the connector cannot be disconnected yet.)

      2. Push the housing lock again and disconnect the connector.

    2. Detach the connector clamp from the front seatback frame sub-assembly.

    3. Remove the 2 nuts and the front seat airbag assembly.

      CAUTION:


      • The nuts must not be reused.

      • Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.