STEERING PAD INSTALLATION

PROCEDURE

INSTALL STEERING PAD
1. Check that the power switch is off.
2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
  
  CAUTION:
  
  Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
3. Text in Illustration
  
  *a Connector Lock
  
  Connect the airbag connector to the steering pad and lock the connector lock.
  Note
  - When connecting any airbag connector, take care not to damage the airbag wire harness.
  - Be sure to only connect the connectors to each corresponding color.
  Tech Tips
  
  Use the same procedure to connect the airbag connector on the other side.
4. Connect the horn connector to the steering pad.
5. Set the steering pad to the steering wheel assembly.
6. Check that the airbag wire harness and horn wire harness are not pinched.
7. Text in Illustration
  
  *a Upper Pin
  
  *b Lower Pin
  
  Push the horn button assembly to attach the 3 pins carefully.
  Note
  - Make sure that the pins are securely inserted into the steering holes.
  - Make sure to engage the 2 upper pins first.
  - Make sure that the steering pad is securely installed.
INSTALL LOWER NO. 3 STEERING WHEEL COVER
1. Attach the claw to install the lower No. 3 steering wheel cover.
INSTALL LOWER NO. 2 STEERING WHEEL COVER
1. Attach the claw to install the lower No. 2 steering wheel cover.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSPECT STEERING PAD
1. Make sure that the horn sounds.
  
  Tech Tips
  
  If the horn does not sound, inspect the horn system Click here.
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here
INSPECT SRS WARNING LIGHT

Click here
INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

Click here
INSTALL LUGGAGE COMPARTMENT FLOOR MAT

Click here

Text in Illustration
*a	Upper Pin
*b	Lower Pin