FRONT DOOR LOCK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • A bolt without a torque specification is shown in the standard bolt chart Click here.

PROCEDURE


  1. INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here

  2. INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  3. INSTALL FRONT DOOR LOCK ASSEMBLY LH

    Note


    • When reusing the removed front door lock assembly, replace the door lock wiring harness seal on the connector with a new one.

    • Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

    • Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door lock assembly.


    1. Apply MP grease to the sliding parts of the front door lock assembly.

    2. Install a new door lock wiring harness seal to the front door lock assembly.

    3. A000NC5E01
      Text in Illustration
      *A w/o Double Locking System
      *B w/ Double Locking System

      Insert the front door lock open rod to the front door lock assembly.

    4. Make sure that the front door lock open rod is securely connected to the front door lock assembly.

    5. Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    6. Connect the connector.

  4. INSTALL FRONT DOOR OUTSIDE HANDLE COVER LH

    Click here

  5. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  6. INSTALL FRONT DOOR GLASS RUN LH

    Click here

  7. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  8. INSTALL FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. INSTALL FRONT DOOR ARMREST SET BRACKET LH

    Click here

  10. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

    Click here

  11. INSTALL DOOR FRAME GARNISH LH

    Click here

  12. INSTALL FRONT DOOR TRIM COVER LH

    Click here

  13. INSTALL FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  14. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  15. INSTALL COURTESY LIGHT ASSEMBLY

    Click here

  16. INSTALL FRONT DOOR HOLE COVER

    Click here

  17. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  18. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  19. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  20. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  21. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  22. CHECK SRS WARNING LIGHT

    Click here