BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB0

DTC Code DTC Name
C1AB0 Short to +B in Outer Mirror Indicator(Master)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a +B short in the outer rear view mirror indicator RH.

DTC Code DTC Detection Condition Trouble Area
C1AB0

Both of the following conditions are met:


  • Blind spot monitor system is on.

  • The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time.


  • Harness or connector

  • Outer rear view mirror assembly RH

  • Outer mirror RH

  • Front multiplex network door ECU RH

  • Blind spot monitor sensor RH

WIRING DIAGRAM

A000SSNE06

CAUTION / NOTICE / HINT

Note

When checking for DTCs, make sure that the blind spot monitor system is on.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB0 is not output.

    OK
    NG
  2. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER MIRROR RH)


    1. Disconnect the T53 blind spot monitor sensor RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T53-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

    OK
    NG
  3. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - FRONT MULTIPLEX NETWORK DOOR ECU RH)


    1. Disconnect the T53 blind spot monitor sensor RH connector.

    2. Disconnect the Q4 front multiplex network door ECU RH.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T53-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

    NG
    OK
  4. CHECK OUTER MIRROR RH


    1. Replace the outer mirror RH Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB0 is not output.

    OK
    NG
  5. CHECK OUTER REAR VIEW MIRROR ASSEMBLY RH


    1. Replace the outer rear view mirror assembly RH Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB0 is not output.

    OK
    NG
  6. CHECK FRONT MULTIPLEX NETWORK DOOR ECU RH


    1. Replace the front multiplex network door ECU RH Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs and check if the same DTC is output again Click here.

      OK
      DTC C1AB0 is not output.

    OK
    NG