TELEMATICS SYSTEM(w/ Telematics Transceiver), Diagnostic DTC:B15DE

DTC Code DTC Name
B15DE Telematics Transceiver Location Data Blackout

DESCRIPTION

The telematics transceiver checks the reception condition of the location data every minute after the power switch is turned on (ACC). If the location data is not received from the multi-media module receiver assembly for 5 minutes, this DTC will be stored.

DTC No. DTC Detection Condition Trouble Area
B15DE Location information from USB communication is interrupted

  • Harness or connector

  • Telematics transceiver

  • Multi-media module receiver assembly

WIRING DIAGRAM

A000RXOE09

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK Click here.

PROCEDURE


  1. CHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again.

      Result
      Result Proceed to
      B15DE is output A
      B15DB and B15DE are output B
      No DTCs are output C

      Tech Tips

      If B15DB is output, perform troubleshooting for B15DB first.


    B

    GO TO B15DB Click here

    C

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - TELEMATICS TRANSCEIVER)


    1. Check the installation condition.


      1. Check the USB communication cable (digital communication cable) between the multi-media module receiver assembly and the telematics transceiver for any installation or connection problems.

    2. Disconnect the N145 multi-media module receiver assembly connector.

    3. Disconnect the N146 telematics transceiver connector.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      N145-4 (USBV) - N146-4 (USBV) Always Below 1 Ω
      N145-2 (USBG) - N146-2 (USBG) Always Below 1 Ω
      N145-1-2 (USB+) - N146-1-2 (USB+) Always Below 1 Ω
      N145-1-1 (USB-) - N146-1-1 (USB-) Always Below 1 Ω
      N145-1-3 (USBS) - N146-1-3 (USBS) Always Below 1 Ω
      N146-4 (USBV) - Body ground Always 10 kΩ or higher
      N146-2 (USBG) - Body ground Always 10 kΩ or higher
      N146-1-2 (USB+) - Body ground Always 10 kΩ or higher
      N146-1-1 (USB-) - Body ground Always 10 kΩ or higher
      N146-1-3 (USBS) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE TELEMATICS TRANSCEIVER


    1. Replace the telematics transceiver Click here.


    NEXT

  4. CHECK DTC OUTPUT


    1. Check the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again.

      OK
      B15DE is not output.

    OK

    END (TELEMATICS TRANSCEIVER IS DEFECTIVE)

    NG

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here