PROCEDURE
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery terminal notice before proceeding with work Click here.
When replacing the multi-media module receiver assembly or telematics transceiver, perform the vehicle contract setting (See page , Click here .
The safety connect device uses the telematics transceiver to provide access to the network service.
The telematics transceiver has a DCM ID (described on the label attached to the telematics transceiver).
REMOVE LUGGAGE COMPARTMENT FLOOR MAT
REMOVE LUGGAGE COMPARTMENT TRIM COVER LH
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL
REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET
Remove the 2 screws.
Detach the 2 claws and 2 clips.
Pull out the multi-media module receiver assembly with bracket.
Disconnect the connectors and remove the multi-media module receiver assembly with bracket.
REMOVE NO. 1 ION GENERATOR SUB-ASSEMBLY
REMOVE NO. 1 RADIO BRACKET
Remove the screw labeled A and ion generator bracket.
Remove the 3 screws and No. 1 radio bracket.
REMOVE NO. 2 RADIO BRACKET
Remove the screw labeled A and ion generator bracket.
Remove the 3 screws and No. 2 radio bracket.