AMPLIFIER ANTENNA INSTALLATION

PROCEDURE

1. INSTALL AMPLIFIER ANTENNA ASSEMBLY

   
   

   1. Use non-residue solvent to clean the area on the glass where the antenna will be installed.

      Note

      Do not use non-residue solvent to clean the antenna's contact points. Doing so may cause improper contact between the antenna and glass.

   2. Install the amplifier antenna assembly with the 2 nuts.

      Torque:

      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note

      
      

      • Just before installing the antenna to the glass, remove the protective cover of the antenna's contact points.

      • When removing the protective cover of the antenna's contact points, make sure the cover does not touch the contact points.

      • Never touch the contact points after removing the protective cover.

   3. Attach the 2 clamps.

   4. Connect the 2 connectors and install the amplifier antenna assembly.

2. INSTALL ROOF HEADLINING

   Click here

3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

   Click here

5. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

   Click here

6. CHECK SRS WARNING LIGHT

   Click here