REAR PACKAGE TRAY SPEAKER INSTALLATION

PROCEDURE

1. INSTALL REAR HEADER SPEAKER ASSEMBLY (w/ Mark Levinson Speaker System)

   Tech Tips

   Use the same procedure for both rear header speaker assemblies.

   
   

   1. 

      Connect the connector.

      Note

      Do not touch the cone of the speaker.

   2. Temporarily install the rear header speaker assembly by attaching the clip of the speaker to the upper back panel.

   3. Install the bolt.

      Torque:

      7.5 N*m  { 76.5 kgf*cm, 66 in.*lbf }

2. INSTALL NO. 2 PACKAGE TRAY TRIM PANEL ASSEMBLY

   Click here

3. INSTALL REAR NO. 3 SPEAKER ASSEMBLY

   
   

   1. 

      Install the rear No. 3 speaker assembly with the 4 bolts.

      Torque:

      7.5 N*m  { 76.5 kgf*cm, 66 in.*lbf }

      Tech Tips

      Tighten the bolts in the order shown in the illustration.

   2. Connect the connector.

      Note

      Do not touch the cone of the speaker.

4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY

   Click here

5. INSTALL CENTER STOP LIGHT COVER

   Click here

6. INSTALL INNER ROOF SIDE GARNISH LH

   Click here

7. INSTALL INNER ROOF SIDE GARNISH RH

   Click here

8. INSTALL REAR SEAT SIDE GARNISH LH

   Click here

9. INSTALL REAR SEAT SIDE GARNISH RH

   Click here

10. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

11. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

12. INSTALL BENCH TYPE REAR SEATBACK ASSEMBLY

    Click here

13. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY

    Click here

14. INSTALL REAR SEAT HEADREST ASSEMBLY

    Click here

15. INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

    Click here

16. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

17. INSTALL LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

18. INSTALL LUGGAGE COMPARTMENT FLOOR MAT

    Click here

19. CHECK SRS WARNING LIGHT

    Click here

20. CHECK SEAT HEATER OPERATION (w/ Seat Heater System)

    Click here